|
Tractor Talk Discussion Board |
Re: Case 90 series and 70 series tractors
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by big jt on September 19, 2004 at 00:28:51 from (206.72.54.246):
In Reply to: Case 90 series and 70 series tractors posted by R Wyler on September 18, 2004 at 18:32:12:
IMHO the 90 series is ten times the tractor that the 70 series is. It is in creature comforts mostly though. The basic mechnicals are the same (engine and trans share a lot of parts). The main differences as I see them are as follows Battery placement. On the 70 series they are both in the same tray under the left side of the cab which has to be pulled out and off the rails unhooking the battery cables as you go. The 90 series has them in a nice tray that swings out and makes servicing them 100 times easier. Cab. Don't even begin to think the cabs are the same. The dash and it's shrouding are connected to the frame of the tractor on the 70 series. perfect for conducting heat and noise right up in the cab. 90 series the cab is a isolated pod with all things in the cab being rubber isolated from the rest of the tractor. The hydraulics of course went to closed center on the 90 series. Don't know what you are intending to do with the tractor. If all you want here is to raise and lower implements either will work fine. The 90 series does have a float position and flow controls however. Due to the cable connection on the 90 series those remotes are a little more difficult to feather. We have had a 1070 which we bought new and currently have a 2290 and 2294. For reasons stated above I was happy to see the 1070 hit the road. Hope this answers your questions. JT
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let�s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|