Re: Farmall H won't start

Posted by RAB on September 14, 2004 at 08:31:00 from (195.93.34.11):

In Reply to: Re: Farmall H won't start posted by RandyWie on September 14, 2004 at 07:24:13:

You should se a spark when cranking with the power on, if the HT leaad from the coil is held about 3-5mm from the block. It will not spark if it is touching the block (no air gap to jump).
If there is no spark, it doesn"t mean the coil is bad. The most likely fault is with the contact points if no spark, or moisture in the distributor cap if there is.
May be an issue with power to the coil, rotor in dist cap, condenser and others, as well as coil could be bad. Needs testing out before spending. Contact point set is cheaper than coil, especially if you then have to buy the poiints as well!!!
Good luck and re-post with what you find.
Regards, RAB

Follow Ups:

• Re: Farmall H won't start RandyWie 08:44:06 09/14/04 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]