Tractor Talk Discussion Board |
Re: OT. Ford Pickup
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JT on September 14, 2004 at 06:06:23 from (68.76.171.26):
In Reply to: OT. Ford Pickup posted by Jerry Cent. Mi. on September 13, 2004 at 16:41:25:
I have a 2000 F250 4 door with a 7.3 PS. Love the truck, get 16-20 mpg empty, never checked it pulling a trailer. Has the power to pull about anything I hook onto it. Now the downside. I pull a trailer quite often, all tag trailers, with an M Farmall, pulled it great, no problem, put a trailer on it that had a gross weight of a little over 8000 pounds, this is where it gets a little squirrely, it pulls fine going down the road, does not have a lot of problems stopping, but going around a curve, the trailer has a tendancy of pushing the truck a little, this is where I think a dually would be much better. Don't get me wrong, it is not bad enough to feel unsafe, but with the weight you are looking to pull, it will get worse, the more weight you put on the truck, the more it could try to push you when going around a curve.
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|