Tractor Talk Discussion Board |
Re: Cheapest way to erect a shed
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Nebraska Cowman on September 04, 2004 at 17:40:46 from (65.162.146.48):
In Reply to: Cheapest way to erect a shed posted by Phil from Maryland on September 04, 2004 at 15:17:36:
I've built several buildings with poles or switch ties and used lumber and used tin. I don't think there are two alike but they shed weather. Some have the rafters running crossways with just the tin directly on, others have traditional rafters and either inch or two bys the other way. Just depends what material you have available. I am going to put another lean-to on the shop this month as soon as i can find some 12 foot 2 bys. For this I am planning to use 2x12s 20 fot long for rafters and then run 2x6s or 2x8s about 4-6 feet apart. I have another shed that has steel purlins and we put them 8 feet apart. You can't walk on the roof without useing a plank but what do i want to go up there for? It don't leak. Right now I have a dozen tractors housed and two pickups. And I don't have $200 of my own money in the whole works. OK, so I cheat, My landlord bought the new tin for the one building. It is the only one that we built with new material, 24 X 40 for less than $1500.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|