Tractor Talk Discussion Board |
Re: Crushed roller bearing?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by txblu on September 03, 2004 at 05:51:48 from (199.46.199.230):
In Reply to: Crushed roller bearing? posted by Coloken on September 02, 2004 at 20:13:38:
I think a bearing is made from a preselected metallic powder which is placed in a mold and a piston (press) comes down on it and literally smashes it into molecular attachment. Really tough, but brittle. I have hammered on bearings and races before and they take pounding for a time then yield by desintegrating. That tells me that a constant load is not a failure mechanism for the bearings mentioned; shock load is. So where is the source of the shock? I doubt that the shock of a tire on pavement is adequate. My 18 wheeler experience with high loads for long periods on roller bearings is a graying and dulling of the surface with slight pitting. If heat is included, due to inadequate lubrication, then there is some purpling of the medal. My 2c. Mark
Follow Ups:
Home
| Forums
Today's Featured Article -
Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let’s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|