|
Tractor Talk Discussion Board |
Re: Baler questions.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by txblu on August 12, 2004 at 08:21:57 from (199.46.199.233):
In Reply to: Re: Baler questions. posted by James in NC on August 12, 2004 at 07:50:45:
Interesting comment. I bought this baler a couple of years ago and guess it is an '85 model. I'm sure the belting was original. Belt was the mini-roughtop which is pretty abrasive (not as good as chevron) and was worn to the point where it was smooth. I bale sudan sorghum cross hay. It is stemmy and gets to 5 or so ft. Was having a bear of a time getting the roll to start; once started things were fine. Decided that my belts were slipping over the stemmy stuff and not grabbing it. Hence the decision to go for the chevron belt. Best thing I ever did. I can whack a windrow now with no critical attack parameters and not even look back cause I know the roll has started (but I do anyway). Fast, slow, side, center, large/small windrow, stemmy, fluffy, dry, doesn't matter any more. Mark
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
