|
Tractor Talk Discussion Board |
Re: Murphy's Laws of tractor repair
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Fawteen on August 03, 2004 at 03:47:43 from (66.100.255.133):
In Reply to: Murphy's Laws of tractor repair posted by Ryan on August 02, 2004 at 15:58:52:
I hadda split my little 750 JD to replace a leaking gasket between the transmission and rear end. For reassembly there are two splined shafts that need to line up, the rear end driveshaft and the PTO shaft. The first time I attempted to roll the rear end back in place and mate it up with the transmission, I wiggled it once and KERTHUNK! it rolled right into place. I stood there for a moment scratching my head thinking "That just ain't natural. SOMETHING must be screwed up." So, I rolled it back out to check. Looked like everything was lined up properly, so I rolled it back into place and KERTHUNK, it just popped right into place again, nary a problem. No parts left over, and only $15 worth of parts to fix a John Deere on the first try. I think I'd be smart to never work on that tractor again, as I've obviously used up all the luck I'm ever going to have in that department.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|