Tractor Talk Discussion Board |
Re: Best - Offset Disk
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by TomTX on August 01, 2004 at 14:25:01 from (12.74.218.57):
In Reply to: Best - Offset Disk posted by bwhite on August 01, 2004 at 07:27:58:
Around here in TEX the most sought after offset disk is the Miller. Where are you located. The Miller had a very good frame and can be rebuilt almost forever. Also Athens are very good offsets, still built in Tenn. I have a 7 1/2 foot John Deere, but it is a very old one which I rebuilt. Suits my MF 690 at 67 PTO HP. With your 115 HP you can pull about a 10 - 12 foot Miller with 24 inch blades on it. You need 10 PTO HP per foot of offset width to really do a good job with one. Let me know if you are near here, I know of a couple of good Millers that are rebuilt.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|