|
Tractor Talk Discussion Board |
Re: Re: Re: how to weld draw bar
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by thurlow on July 16, 2004 at 18:58:23 from (65.255.98.21):
In Reply to: Re: Re: how to weld draw bar posted by Ray,IN on July 16, 2004 at 18:48:38:
I have fixed several (also built some from scratch) using either a rod of the correct diameter or a purchased implement pin (has threads, which are not used as such).Cut a "slot" out to a depth of about 3 inches in the drawbar.....weld the pin/rod in. It may not look completely original, but can be made to look good, depending on the effort you put into it.....
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Reflections of the Fifties - by "Country" Elliott. I remember rowing up in the 1950�s in a small, rural town in northwestern New Jersey. The closest town to ours was only 3 miles away, and there were seven dairy farms in the areas of these two country towns. We had 5 acres, and because my Dad was a salesman and not a dairy farmer, he let the Bockovens, who owned the Willow Tree Dairy farm most of our land.
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
