Tractor Talk Discussion Board |
Re: how to weld draw bar
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by KX on July 15, 2004 at 12:39:15 from (38.115.0.254):
In Reply to: how to weld draw bar posted by dick on July 15, 2004 at 07:44:37:
If it is worn from contact/rub, I would fill in the worn area with another piece of steel fitted as best i could. Then I would weld a contact pad so it couldn't wear so easily in that same place. You may also want to add to the width of it in that area with 3/4 sucker rod welded to both sides. You don't want to try to just "fill" the area with welding rod, weld more to it to make it stronger and prevent future wear. I always try to fix something like by making it stronger than it was before.
Follow Ups:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|