|
Tractor Talk Discussion Board |
Massey 20 carb ajd
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by thom144e on July 05, 2004 at 18:38:13 from (64.136.164.36):
I got water in the fuel tank = rust = poor to no running tractor... Same symptoms I now have after I rebuilt the carb. runs for a bit then stops. I've rebuilt the carb on my Massey 20, but now I am having difficulties. I've searched the archives, and looked at a ford web site for rebuilding a Marvel-Schebler carb, but I continue to have difficulties. getting the tractor to run. (No I do not know which model I have ... see below) There is no ID plate on the carb, but I think it is a TXS 361 SO far: tried ajd idle and main needle valves and the best start up and running I got was for both to be open about two turns. After the engine gets hot it stops. It seems to only run when the throttle lever is set all the way at lowest speed. If I open it up the engine dies. pulling on the choke wil help this a bit, but only for a few seconds. Does this suggest that the main valve is dirty? It seems to operate as it will kill the engine if I close it. The kit I bought to overhaul the carb had 4 idle valves in it, I took the one closest to the size of the one being replaced. It does idle a bit fast, If I close the throttle plate adj I think I can get this down , but I followed the specs for setting it. Perhaps I used a valve seat that was a bit too big? (can't find the serial numbers. Welded over ) so I am not sure what type of Massey I have . It was sold to me as a 20. Red fenders, Massey on the front of the hood only, red hood, grey engine.. if any of this helps.
Thanks for any suggestions thom
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|