|
Tractor Talk Discussion Board |
Re: OT- axle placement on trailer
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BFarr on June 18, 2004 at 18:48:22 from (165.121.145.241):
In Reply to: OT- axle placement on trailer posted by jimNCal on June 18, 2004 at 18:25:20:
When I build my last trailer I researched several sources and they seem to agree that 60-40 was the ratio to be followed. The center of the axles should be 60% back from the front (measured at the bed not including the tongue). When I did this on an oversize dual axle trailer it had a bit more tongue weight than I liked but too light would be more of a problem
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Step by Step 12-Volt Conversion - by Bob Melville. Below are step by step instructions to convert a 6 volt Farmall M or Super M with battery (not magneto) ignition to a 12 volt alternator electrical system.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|