Re: Stabilizer Bar

Posted by RWK in WI on May 05, 2004 at 07:34:38 from (169.207.137.105):

In Reply to: Stabilizer Bar posted by Dennis In Michigan on May 04, 2004 at 16:40:14:

Dennis,
What you manual is talking about are bars that
go from the end of the 11 hole hitch bar on the
three point arms to the top link and hold the
lift arms at a set height. This held the hitch
bar a one height so the trailer / manure
spreader couldn't lift the hitch as the load
shifted to the rear. With the bars in place the
3pt arms couldn't move with out damaging
something - usually the bars bent.
The bars that Jack is talking about go on the
ends of the 3pt implement and then to
brackets under the fenders. These bars keep
the 3pt and implement from swaying side to
side and are used with implements other than
plows and some cultivators to make the unit
more stable. Since they pivot at both ends
like the 3pt arms they move with no damage to
the tractor.

Follow Ups:

• Re: Re: Stabilizer Bar thurlow 08:41:36 05/05/04 (1)
  • Re: Re: Re: Stabilizer Bar paul 14:30:54 05/05/04 (0)

Post a Followup Name: E-Mail: Subject: Re: Re: Stabilizer Bar Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]