|
Tractor Talk Discussion Board |
Re: Right Angle Drill -=attachment or dedicated?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RAB on March 26, 2004 at 14:24:00 from (195.93.34.11):
In Reply to: Right Angle Drill -=attachment or dedicated? posted by DumOleBob on March 26, 2004 at 08:06:58:
As the others said, really. The tool for the job is the way to go. An adaptor is always a compromise - and there are some good examples around - but I would bite the bullet and buy good and buy once!
I am sure you will get better value than $40 a hole as you find more jobs you might have compromised on building, or struggled to do easily. Anyway after that first year each hole would virtually free - just your way of accounting the cost.
Just my 02p worth.
Regards, RAB
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather�s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
Latest Ad:
L35 Kubota
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
