Tractor Talk Discussion Board |
Re: equip. you've fabricated from scratch
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by john on March 24, 2004 at 22:03:36 from (66.157.36.119):
In Reply to: equip. you've fabricated from scratch posted by daveVT on March 24, 2004 at 16:59:59:
I built a 5x8 trailer with a old axle I had and some angle iron picked up here and there. When I needed a stock trailer I got some extra concrete rebar that was left over on a job and enclosed the top with the rebar. The entire thing from the floor up is made from rebar; including the doors. I have just finished a hitch attachment for my tractor. Rather than buy or make a separate one purpose thing I just welder the center piece off a old truck step bumper on the back of my box scraper. Works great; just hook trailer to box scraper and go.
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|