|
Tractor Talk Discussion Board |
Re: Sickle Mower
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by TractorMike on March 22, 2004 at 20:44:01 from (64.12.117.22):
In Reply to: Sickle Mower posted by J on March 22, 2004 at 14:24:37:
It is possible to make your own pitman arms. I have an old ford 501 sickle mower and broke 2 pitman arms before I got smart and made one. What I did was I went to lowes and got a piece of 1x4 8ft and cut it to length then I took 2 pieces of 3/16 steel and bolted one on each side of the wood then drilled the holes and voila, You have a pretty strong pitman arm. The width of the 1x4 and 3/16 steel workes out to the same or about the same as the orignal. TractorMike
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
