Re: bearing undersize

Posted by 49 Cubber! on March 22, 2004 at 18:10:31 from (206.74.216.89):

In Reply to: bearing undersize posted by jeff sadler on March 22, 2004 at 12:13:24:

I dont know the answer to your question,but you should get the crank machined BEFORE you order your bearings.if the crank has been turned or even if its standard,there will be SOME wear which will throw off the mic as to what you have,say if its .010 undersizes and wore an additional .002 then thats .012 under,you wont find bearings like that,usually they are .010,.020,and .030.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Re: Re: bearing undersize Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]