|
Tractor Talk Discussion Board |
Allied Loader vs. Bush Hog
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Phil in MS on March 04, 2004 at 05:58:26 from (207.203.128.29):
I have been looking for a loader for my MF255 50hp tractor. I like the MF236 and the Bush Hog 2426/2425 and 2400. However have been unable to find one that is priced within my means. A dealer has an Allied 394 with standard cylindars that seems to be priced right but I am concerned that 5X5 or 6X6 bales of hay baled in a JD baler with a 130 to 140 hp tractor may stress this unit to the higher end. It probably would be OK with a set of the optional cylindars that would be extra. I really like what I have seen of the Bush Hog, I just haven't found one not on a tractor that someone is willing to part with. Allied's website indicates that the 395, 495 and 595 are matches for the MF255 each one just a little stronger/heavier than the previous one. My friend and I normally handle about two hundred rolls of hay a year. IS THE 394 ALLIED LOADER TOO SMALL ON MY MF255 FOR WHAT I WILL BE HANDLING? Thanks for any insite.
Follow Ups:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
