|
Tractor Talk Discussion Board |
Re: Remote Hydraulic filter install?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mark on March 01, 2004 at 09:25:56 from (199.46.199.231):
In Reply to: Remote Hydraulic filter install? posted by Rod M1 on February 29, 2004 at 14:53:17:
I can't answer your question but think the dump is in the sump. Not sure if there is a "low side" plug on the side of the casting where you can tap in....I do know there are high side plugs. But I am glad you are asking the question to maybe save your life from putting it in the high side. I know we forumed some questions not long ago and I don't remember if you were the one asking or not. If your NH parts man is an old timer he can offer lots of tips. I wouldn't put it in the pump suction line as it would (probably) cause your pump to cavitate and not work properly. Sorry I don't have the answer. Mark
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
