Tractor Talk Discussion Board |
Distributor cap of 8N
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Michael Daly on February 09, 2004 at 20:48:05 from (65.249.0.228):
My venerable work horse has been difficult to start at various times since purchase four years ago. Have rebuilt then replaced the carburator, performed a tune-up about 3 yrs ago, and most recently replaced the battery. Still no go. Checked the spark plug wires and they seemed OK and worked my way to the distributor cap. The rotor looks OK but one of the contacts in the dist. cap is almost 80% gone, but the other three contacts look OK. What does this mean (besides the need to replace the dist. cap)? Is one of the plugs arcing inside and drawing current? Is it a hidden flaw in one of the spark plug wires? Does the rotor have to be replaced if it looks OK? Is it the fault of my bad karma? When I was able to start it about three months ago the engine did not run rough. Thanks
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|