Tractor Talk Discussion Board |
Re: Re: Re: Your carb should NOT leak......Carb 10
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob on February 03, 2004 at 13:10:56 from (66.163.134.177):
In Reply to: Re: Re: Your carb should NOT leak......Carb 101 posted by Scott on February 03, 2004 at 13:00:56:
Scott, I agree with you. It amazes me the number of people that buy a new carb, even an imported no-name knock-off, because they do not realize their old carburetor can be repaired, or they install a new carburetor without cleaning the fuel system, and installing a good filter. Soon, the new "good" carburetor behaves just like the old "bad" unit. We do a lot of repair work on older farm-type vehicles, and some people DEMAND a rebuilt carburetor. With some exceptions, I cringe at the thought because of some of the cobbled-up factory rebuilt carburetors we've seen these last years. Apparently, good cores are hard to come by, and the rebuilders sometimes use cores that should have been scrapped.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|