|
Tractor Talk Discussion Board |
Re: Dodge 1500 Ram with 360 Magnum
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike M on January 15, 2004 at 05:46:24 from (24.140.40.90):
In Reply to: Dodge 1500 Ram with 360 Magnum posted by moonlite on January 14, 2004 at 09:45:48:
I have a 1996 ram 2500 with a 360 gas and it has been a good truck. I have not drove a new hemi yet can't afford one so I'm not going to tempt myself. A test drive won't tell you jack unless you can pull a trailer while doing it. The car and truck magazines don't like the old 360 cause they can't burn rubber from stoplight to stoplight.My 360 is doggy at take off, 355 rear gears but will pull real good and hold the hills good. I don't pull a trailer much but can if I want to just fine.If I was trailering all the time with big loads I would probabally opt for the cummins. In a 1500 series that engine should handle more than the truck should as I have no problem going over GVWR in my 2500 HD series.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|