Tractor Talk Discussion Board |
Re: Re: Re: Re: Anyone know Balarus Tractors??
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Big Jim on January 09, 2004 at 09:08:57 from (199.141.125.33):
In Reply to: Re: Re: Re: Anyone know Balarus Tractors?? posted by jamds on January 08, 2004 at 04:48:08:
Sorry about the late response. I was out of town yesterday. To answer your question, I run an 825. The similar current model is the 8345. I don't think there is much difference between the 8345 and 9345 (100 HP). The 9345 uses a turbo and runs at 1800 RPM. The 8345 runs at 2200 RPM with no turbo. Sometimes they put larger rubber on the 9345's. That's about the only difference. Do not get an 825 or 925 if you can afford a 8345 or 9345. The newer series has has the Husco valves, the same used by John Deere. They do not have any hydraulic leak problems, plus they have a one lever joystick control for hyraulics and the 14 speed synchro tranny (easier shifting).
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|