Tractor Talk Discussion Board |
Re: Farmall H Axle Housing
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by CRUSADER on December 26, 2003 at 11:46:35 from (216.31.64.79):
In Reply to: Farmall H Axle Housing posted by Linda Kinney on December 26, 2003 at 06:41:25:
Hey it's been a while since I tore into an H or M Farmall. But if memory serves me right, You will get very little gear oil inside of the axle housing. The inner bearing will get lubricated well enough from the gear oil in the transmission and rear end. The outer bearing, best pack it with wheel bearing grease and give it a shot or two of gun grease when you use it. Hope this info is correct and helps you out. later days mate, Jim
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|