|
Tractor Talk Discussion Board |
Re: removing stumps?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Cliff on December 17, 2003 at 18:43:27 from (204.96.24.100):
In Reply to: removing stumps? posted by Tom In Texas on December 17, 2003 at 13:07:16:
Please be carefull about pulling stumps with anything attached to your 3 point hitch. I met a guy in an ER a few years ago that was lucky to still be here. His 8 N went over on top of him doing the same thing. I bought a used stump grinder that mounts on the tractor 3 point lift and have found it much faster and also easier on my tractor clutch. IT does not leave a stump hole. Even been asked to do some for the folks around the area for cash. Guess a guy could make a few bucks with one. If he had the time. Mine is a used Ashland Stump Master. By the way I am located in East Texas. What part of Texas are you located? Good Luck Cliff
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
50 Tips for Ford N Owners - by Bruce Haynes. Over the years of owning these three tractors, I have managed to refresh what little mechanical knowledge I had and add a little more, thanks to the wisdom and helpfulness of many fellow N owners. So, now it's my turn to share a few of the tips I've picked up.
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|