|
Tractor Talk Discussion Board |
Re: 730 power steering lock
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Greywolf on December 09, 2003 at 05:55:38 from (209.23.142.29):
In Reply to: 730 power steering lock posted by mark on December 08, 2003 at 21:14:58:
My 70 used to do the same thing after it was rebuilt from a fire (leaky gas cap without an anti splash tube in the tank). Not sure what was done at the time to correct it, I was only 15 at the time and wasn't around for the repair. I have talked to a few others knowledgable on the subject as it now turns hard one way easy the other. What I have been told, and can stand to be correct, is the spool isn't centered. What I do know to attempt or at least start the process (what we did with the mechanic anyway) is jack up the front end so there is no load on the steering and loosen the housing where the steer shaft comes into. Lightly tap back and forth till the unit self centers itself. If it is off (going from memory here) it will self turn one direction or the other. I have also been told of a bushing that might be out for the hard steering part, but I don't have a service manual outlining the R & R. Hope this helps for a start. Bruce
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|