Case model V (or VA) clutch specification needed ?

Posted by Alberta Mike on September 03, 2003 at 09:45:02 from (209.47.89.112):

I tried this question on the Case board but no responses so I'll try it here. I am reassembling a 3-spring Auburn clutch on a Case model V. It would be pretty much the same clutch as is on the VA and probably similar to clutches on other makes as well. I have replaced the 3 throwout arms and springs on the pressure plate assembly. Now I need to adjust the height of each of the three arms using the adjusting bolts and lock nuts. I know that all three arms have to be adjusted to the same location or height (within 0.005" of each other) so that the throwout bearing contacts them at the same time, but I don't know at what location or height to adjust the arms to. There is quite a range to which they can be set. None of the manuals I have here give a specification nor do they state where to take the measurement from. Any help or advice would be appreciated if you might be able to help.

Follow Ups:

• Re: Case model V (or VA) clutch specification need rod 14:34:51 09/04/03 (1)
  • Re: Re: Case model V (or VA) clutch specification Alberta Mike 09:29:28 09/05/03 (0)

Post A Followup Name: E-Mail: Subject: Re: Case model V (or VA) clutch specification needed ? Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]