|
Tractor Talk Discussion Board |
Re: Regarding the advice given
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by PNR123 on August 25, 2003 at 10:29:05 from (24.71.223.142):
In Reply to: Regarding the advice given posted by PNR123 on August 24, 2003 at 22:05:53:
I've just returned from the "viewing" of the 8N and here's the low down , the loader is in OK looking shape , however it is from a Minneapolis tractor and has never actually been fitted to the 8N , the sickle mower is a Dearborn model#14-15 (rusty) and the tractor tin is nice and both rear tires are new and there is a rather gaping hole in the block & oilpan where a rod tried to exit , I think I'll pass , I'm now off to see a 48 8N that is "rebuilt" w/FEL (mechanical dump) , 6' drawbar , and new rubber this one's asking $4300CAD ($3070USD) seems a bit high but we'll see , thanks again guys
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Storing Your Tractor - by Staff. If your tractor is going to be stored for any length of time, a few precautionary measures are helpful in preserving various parts, also in avoiding future difficulty. Store tractor under cover. If impossible to place tractor under cover, be sure to cover air stack and exhaust pipe. Drain radiator and engine block. To avoid gum content collections, drain both fuel tanks and carburetor. Leave radiator and fuel caps slightly loose to protect gaskets. Block tractor up to remove weight from tires and to keep tires from contact with moist floor.
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
