Tractor Talk Discussion Board |
Re: Need some ideas
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Unimog on August 08, 2003 at 12:45:17 from (64.12.96.236):
In Reply to: Need some ideas posted by Scott on August 08, 2003 at 12:08:06:
The rollback truck is a good safe way of doing it. The truck should have hydraulics that will lift up to the trailer so knowing the height of the trailer is not that important. Trailers seem to be in the 40" to 48" height with step-decks being about 30-36". I had a tractor delivered one time that was unloaded onto a ramp I built from wood chips and some cement forms. The forms held the chips from crushing too much and I had packed them down good with another tractor. Ive seen them unloaded onto wood pallets, sand piles and snow banks. Tractors are pretty easy because of the high ground clearence, but that old Chevy will need some good and stable. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|