Tractor Talk Discussion Board |
Re: Re: Re: Re: Re: Re: Re: How much wieght?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ed on August 08, 2003 at 10:31:03 from (198.185.163.7):
In Reply to: Re: Re: Re: Re: Re: Re: How much wieght? posted by kydirtfarmer on August 08, 2003 at 04:38:09:
I think I would just remove the fluid and leave it at that. I use 1,000lb of suitcase weights on the front of my 70hp tractor to pull a 3-16 rollover plow and no fluid in the rear tires or wheel weights. The tires rarely slip. If they do I just lift the plow a little and have all the weight I need. Oh, I'm using 13" tires in the back and 7.50's on the front plowing in thick clay type of soils. The front weight is to keep the front end down when picking up the plow and for general stability. With a 3 point hitch plow with the tractor moving all of the benifit plus some is transfered to the rear wheels. Think of a pry bar lifting something up - that 600lbs you have on the front is acting like a lot more. I also pull a IH 37 8" disk with new blades all the way down with our wheel slipage or problem. I can even pull a 14' disk & grain drill (only down enugh to level the field) - wheel slipage isn't the problem HP is
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|