Tractor Talk Discussion Board |
Re: Re: Re: Urgent help needed!!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by kyhayman on August 03, 2003 at 07:17:14 from (64.12.96.236):
In Reply to: Re: Re: Urgent help needed!! posted by Bob on August 03, 2003 at 06:55:17:
Mainly it is personal bias. I've only blown up 2 batteries, both were straight 12v to 12v and were in the tractor (jump starting). Main reasons I like to pull the batteries to charge (I only pull 6v orseries connections): Jump starting puts a lot of strain on the alternator of the jumping vehicle and always a risk of some stray voltage feeding back into some very expensive computer and charging system components. Dealer used that as an excuse back in 90 not to honor about $5K worth of warranty work on a Ford truck I had with a fried computer. Wasn't what happened, they since recalled those computers, but it was enough to void my warranty.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|