|
Tractor Talk Discussion Board |
JD 140 won't start
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jeff on July 31, 2003 at 09:54:32 from (68.72.1.3):
I am reposting my problem from a few weeks ago. HELP!!! I cannot get the starter to engage on my 140. I got the service manual and went over all connections, checked the ignition, and cleaned all connections. I tested the solenoid out of the tractor and when engaged, it closes the circuit across the big terminals (solenoid also works fine without the starter wire hooked up). I bought a new starter and it won't engage either. With the starter off the tractor, I get 12 volts at the starter wire when I turn the key to start. If I connect the starter, I get 0 volts at the starter when the key is at the start position. Sometimes I hear the solenoid click, but most of the time it does not. The battery is 3 yrs old, but shows a full charge (I have charged it in this process also). I also tried jumping it from my truck and get the same problem. The safety switches for the PTO and hydrostaic lever are bypassed (which has always worked before this) and the bypass wire shows continuity from the ignition switch to the solenoid. Could the circuit breaker be bad? It shows 0 ohms (shorted) which should be correct, right? Could the ammeter be bad? It also has continuity through it. I am running out of ideas. Any help would be GREATLY APPRECIATED! Thanks to Ray for sending me the wiring diagram before I received my manual.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Women and Tractors - by Teri Burkholder. The View from the Garage - Never a doubt, everything on our farm is a learning experience. I've been working very hard to get our two rundown Farmall A's sanded, primed , bondo�d, fiberglassed and painted before our big local tractor show called the Tulip Festival. My husband Ben came in the garage one rainy day to see if he could "help". Well if you knew Ben you wouldn't want him anywhere near your spray gun, fiberglass or bondo! So I pulled out the 2 old yucky looking magne
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|