Re: Belarus 250 AS

Posted by Rick in R.I. on July 27, 2003 at 21:06:01 from (152.163.194.184):

In Reply to: Belarus 250 AS posted by caroline corona on July 26, 2003 at 17:09:23:

Hi Caroline.

I have the same tractor, 1993, and although I haven't used the PTO as of yet, if i remember right I didn't have to use low gear to check the pto, I only used low engine speed.

I don't know if this has anything to do with the PTO operation? You said the tractor will not go into low gear for the pto to work. Which low gear did you try? SL1 / SL2?

Again, I don't know if it relates to the PTO, but I know that you can't access the reverse gear. If these speeds are selected in the reverse mode the tractor will not move.

Could the PTO control lever linkage need adjusting?

I'm quoting from my operators manual:
1. Depress the clutch pedal.
2. Start the engine, set the throttle to
low speed.
3. Move the PTO control lever rearward
to engage the PTO shaft.
4. Release the clutch pedal smoothly to
start the laod. Increase engine speed
smoothly to rated engine rpm.
NOTE: THE CLUTCH PEDAL MUST BE DEPRESSED TO ENGAGE OR DISENGAGE THE PTO SHAFT.

The PTO is rated at 540 rpm at 24.0 hp. Be sure not to connect equipment needing more power than the tractor horsepower rating or severe damage will result.

Best of luck.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Belarus 250 AS Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]