|
Tractor Talk Discussion Board |
Re: Gooseneck Trailer
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by rustyfarmall on July 21, 2003 at 10:42:34 from (207.32.13.198):
In Reply to: Gooseneck Trailer posted by Scott KY on July 19, 2003 at 13:44:04:
I own a Trav-a-long, built in Liberty, Kansas. Mine is a tandem axle, but not a dually. Recently, I have been wanting to upgrade to a dually, and have taken a good, hard look at various other brands, Most of what I have looked at so far will not compare with how the travalong is built, so far I have not had a chance to look at the brands you have mentioned, so I will not discredit those. In short, when looking at a trailer, you must get down and crawl underneath, take a good look at the welds, how the wiring is attached, and the general design of the framework, do the main I-beams run all the way back and support the beavertail, or is the tail section built separately and then just welded on? It does make a differance. I looked at one brand of trailer that was welded so poorly I would have been afraid to pull it empty, the various pieces of the tail had not been cut correctly, and they had to lay used bolts in the gaps in order to weld the seams. Yes, this was a brand new trailer. Also, the brand of trailer I see most often is less expensive than the other brands, which is why I see so many of them, but by doing a close examination on those trailers, I understand why they are cheaper, they are not built well.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Adding an Hour Meter - by Steven Gussey. This article tells how I added an electric hour meter to my 1942 Farmall H after rebuilding it. I wanted to keep an accurate maintenance schedule for my rebuilt engine and the implements I use with my tractor, but the H was never available with a tach
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|