|
Tractor Talk Discussion Board |
Re: Carburetor QUESTION - Zenith
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Alberta Mike on June 19, 2003 at 13:27:48 from (209.47.89.102):
In Reply to: Carburetor QUESTION - Zenith posted by Mike D. on June 19, 2003 at 10:50:42:
When you say the main jet, are you referring to the big fuel nozzle (brass) that sticks up at an angle? If so, yes I've seen them in some kits. There is a good article on rebuilding carbs in the "articles" section in the left menu here at YT. If you go to remove the old nozzle, make sure you heat things up good with a plumbers propane torch or even in a barbeque oven or you will twist the old one off in the casting. The heating thing should only be done if the casting is cast iron ... I'm not sure if a pot metal casting would be OK with that method.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
A Tinker�s Guide to Manifold Repairs - by Curtis Von Fange. A common characteristic of keeping older equipment is that some parts to make repairs can be extremely difficult to locate. For example, finding a replacement for a cracked intake or exhaust manifold on a unique tractor or odd brand can be a frustrating and downright impossible mission. So, what is an alternative solution to scraping out that �one of a kind� piece of history? First, decide if you are one to try a repair yourself or have someone else do it. If you are uncomfortable about
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
