|
Tractor Talk Discussion Board |
Re: wiring a GM alternator on Farmall C
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jon Hagen on May 10, 2003 at 17:34:38 from (69.26.17.40):
In Reply to: wiring a GM alternator on Farmall C posted by Mike S on May 10, 2003 at 15:51:01:
To wire a 3 wire Delco 10SI alternator to a mag equipped tractor. 1 convert from pos to neg ground system. This requires installing the battery with the neg post to ground and switching the wires on the amp guage posts to the opposite side so the guage will read correctly with neg ground. 2 Hook the Bat terminal on the alternator rear to the bat wire going to the amp guage. This is the wire that was on the generator's regulator/cutout bat terminal. 3 using an auto parts store alternator plug,wire the #2 sense wire(usually heavy red wire) to the BAT terminal on the alternator rear. 4 Install a two terminal oil pressure switch on the engine and wire 1 terminal to constant battery voltage through a 5 amp fuse holder( the terminal where the pos battery cable attaches to the starter switch is a good place). Wire the other oil pressure switch terminal to the #1 exciter wire in the alternator plug(usually a small white wire). Now when your running tractor's oil pressure turns on the oil pressure switch,it will excite the alternator and start the alternator charging. When you stop the tractor engine the oil pressure switch will open and disconnect the exciter wire from the battery,so no chance of leaving a switch on and discharging the battery. The alternator #1 and #2 terminal numbers are cast into the rear alternator housing just below the regulator plug.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
A Tractor's Point of View - by John Manley. I began my life on August 3,1941. I was actually built at different times and days but I was officially an M Farmall on August 3.I was real nice and shiny. That�s me, in the old picture, third from the left. I was loaded on that train and sent to a little town in South Carolina. I didn�t get to see much of that town. I was moved off the train fast and on to the dealer�s
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|