Tractor Talk Discussion Board |
Re: Question about a Tractor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John Alfred Smith,Jr on April 19, 2003 at 20:52:09 from (208.24.233.29):
In Reply to: Question about a Tractor posted by Pat Kies on April 18, 2003 at 19:27:35:
Pat, MMs are not my long suit, but if this tractor has set out for a number of years, then start LOW. It is easy to go up, not down. How is the rubber on it ? all up or flats all the way around and sank into the ground. If it is stuck and it looks as good as you say start at $200 to $300, If it will turn over,go to your offer It is a matter of how low you are willing to start and still live with yourself. for you might get this tractor for a song , and get to play the tune!!! Good Luck, John A.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|