Tractor Talk Discussion Board |
Re: Where to place axels on a flat deck trailer ???
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Don LC on April 12, 2003 at 08:46:14 from (24.166.240.210):
In Reply to: Where to place axels on a flat deck trailer ??? posted by Alberta Mike on April 12, 2003 at 07:25:47:
Mike, Years ago I took a 3 day course, sponsered by "REESE HITCHES".....they say that on large heavy trailers that 15% of the total loaded weight should be on the hitch.....medium weight, about 12% light wt.like boats and pop-up campers 10%.....I would weigh the total materials that will make up the trailer......I would guess your trailer to be in the heavy range.....If you are interested in talking more about this adjustment e-mail or call me....if you call make it late, around 9 or 10 PM..EST.....Don
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|