|
Tractor Talk Discussion Board |
Re: Re: Re: First tractor puchase....PTO question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by david on March 31, 2003 at 19:12:26 from (64.12.96.236):
In Reply to: Re: Re: First tractor puchase....PTO question posted by paul on March 31, 2003 at 18:12:57:
Paul, Right on the x6x series Fords. The older one like an 801 only had a single stage clutch. Push the pedal in and transmission and pto stopped. But pto would run at engine speed with transmission in neutral. These have a "live" pto, it is connected to the power source, but dependent on a single clutch pedal. That was the big selling point on the 60 series over the 00 series. The 01 series I'm not sure about, never worked on one. The tractors with the lever for the PTO clutches still have a 2 stage clutch, just use a series connection. Usually a Borg and Beck or Laycock. Case/David Brown uses them, too in the 1210 and 1410 (and updated) series. Older 990 uses a parallel linkage with both clutches controlled by the foot pedal. Really takes practice to "feather" a pto on the x6xx Fords. Still get a lot more motion than you want. Best way I've found is to use the starter motor with the PTO engaged and the kill switch out.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Bad Vibes - by Curtis Von Fange. One of the strangest ways to communicate with our tractor is to ask it how it feels. "Ask it how it feels," you say? Yup, ask it how it feels. Now, as with the other articles in this series one has to be able to hear what 'ole blue' is trying to say in response. The nice thing about our old iron friends is that they are usually quite consistent in their response, rather unlike some people I know who might change what they say due to the weather or other mitigating circumstances. But since t
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
