|
Tractor Talk Discussion Board |
Hand cranking idea?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dennis on January 26, 2003 at 12:58:59 from (162.58.35.101):
I am not a tractor restorer myself, but got hooked at all the ingenuity of those brave folks restoring old iron. I've read the article about hand-crank starting various brands of machinery and wondered if the hand held portion of the crank could be modified. If I can describe this idea properly, it would have a straight shaft with the crankshaft engagement on one end, and a solid disc (no spokes) on the other.This way the cranker couldn't get caught in the flailing crank handle if the crank failed to disengage the crankshaft. Just thinking aloud. Maybe the compression is just too much for a hand grip on the edge of a wheel. Any comnments on this?
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let�s make one more addition to our series on hydraulics. I�ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
