Tractor Talk Discussion Board |
Re: stupid question for the day
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John (SC) on January 21, 2003 at 09:59:20 from (206.74.216.38):
In Reply to: stupid question for the day posted by Terry on January 21, 2003 at 07:21:26:
I agreee with Bill,if your having a hard time starting with the hand crank then something needs attention.With everything in good shape itll start up easy enough.The way I start my 14 is turn on the gas,push the choke in,retard the spark to just above the point where it would shut off,pull up on the crank until its jsut about to clicl the impulse on the mag and give it real quick jerk when it gets there.After doing that a couple of timesIll pull the choke lever back out and pull the crank again and it usually fires up then.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|