|
Tractor Talk Discussion Board |
Re: where should I stick my muffler
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Smith on December 31, 2002 at 11:27:34 from (63.147.130.95):
In Reply to: where should I stick my muffler posted by Brian on December 29, 2002 at 20:14:22:
I run into trouble with exhaust pipes and getting into shed doors myself. For short term purposes I removed muffler and drove tractor in without it on. This worked but it was always a pain in the rear to take that hot muffler off, and finding a place for it tell it cooled off. Then I got smart and took a saw and sawed the pipe off the muffler. You could probably do this on both inlet pipe and outlet pipe of muffler. I got by just doing it on outlet pipe. All you really need on there is enough pipe to get on manifold and enough to possibly clamp a rain cap on. This might allow you to have upright exhaust and get into the shed. Just a couple things to think about. The underneath exhaust can more easily start fires, cuase burns if put in the right place, may get in the way, or be damaged if you run over something with tractor. However, I got another tractor that doesn't have the proper heigth of exhaust (it is about face high on operator) and you breath alot of exhaust fumes if you run it all day. I seen a guy one time that was not to proud of his shed and he cut a hole in top of door way for exhaust pipe to go through. Also seen a guy another time dig down in the dirt floor of his shed to lower tractor down as it went through doorway so exhaust could get under the doorway.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|