Re: I twisted off a bushing reducer, HELP!!

Posted by T_Bone on November 15, 2002 at 16:29:34 from (64.154.137.69):

In Reply to: I twisted off a bushing reducer, HELP!! posted by Terry on November 15, 2002 at 15:49:53:

Hi Terry.

Hopefully it's a brass reducer. If brass or steel then take a hack saw blade and cut the bushing in 4 places just until you hit the block threads, do not saw into the block threads, then use a small chisel to colaspe the bushing in pieces to the inside diameter.

Plumbers have a special hacksaw handle that will accept a single blade just for this problem. It leaves the blade tip exposed so it can fit in holes easy to make the cuts.
I think you'll just waste time trying to use an easyout.

Do not rush this job or you will be pulling the head/pump!

T_Bone

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: I twisted off a bushing reducer, HELP!! Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]