Tractor Talk Discussion Board |
Re: causes of accidents?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RAB on November 15, 2002 at 08:27:13 from (195.93.34.10):
In Reply to: causes of accidents? posted by JW on November 14, 2002 at 20:06:39:
It is always regrettable when someone has an accident, but by the definition of 'accident' - an unavoidable occurrence causing harm, or an unexpected event, - a large proportion are not actually accidents from our point of view. Many are due to taking short cuts, either by familiarity or by not considering the consequences, or by not checking out the correct way of doing a job (ignorance or inexperience?). How many times have we got away with something only because we knew what was going on before it got too much out of control? In a lot of these fatal accidents you might consider what should have happened if a third party was injured or killed. If culpability were to be proved, then it was not an accident. Of course, this doesn't help the victims after a fatal incident, but I hope it reinforces our need to be responsible for safety in whatever we are doing. RAB
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|