Tractor Talk Discussion Board |
Re: changing tire
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JMS/MN on November 10, 2002 at 22:30:47 from (63.21.83.90):
In Reply to: changing tire posted by stan on November 10, 2002 at 16:26:14:
Since it's a dual, I assume it does not have fluid in, although fluid can be changed by draining it, and using air pressure in a barrel to replace the fluid. Not easy, but when bucks are tight, a little ingenuity can save some money. As far as breaking the bead loose, you can use a skid loader or loader bucket, position the bucket edge close to the rim and push after all the air is let out and the lock ring on the valve stem is removed. If that equipment is not available, push a 4x4 post against the tire with another tractor to break the bead loose. If the inside bead does not loosen easily, take the wheel off the tractor and use the same method with a bucket or post. Depending on the dual spacing, the bucket/post idea works with the wheel on the tractor for the inside bead. You'll need a couple wide, long, flat irons to peel the tire over the edge of the rim to get the tube out, and a sledge hammer comes in handy too.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|