Tractor Talk Discussion Board |
Re: Just getting started.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JD guy on November 01, 2002 at 15:44:08 from (209.240.198.61):
In Reply to: Just getting started. posted by Chris Allen on November 01, 2002 at 14:30:25:
That F14 sure don't know much about John Deere two cylinder tractors. There not hard to work on! And best of all you can get all kinds of parts, from John Deere and many others. And most of all don't let people tell you John Deere parts are expensive. Most guys that say parts from John Deere are expensive never bought a part from John Deere in there life. I have bought parts from JD, IH, MF. Oliver, MM there all the same. If you need a part you have to pay for it,and most of the time you will not pay more for a part at JD then any others.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|