Tractor Talk Discussion Board |
Re: NH Round Baler
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John on October 02, 2002 at 17:04:42 from (152.7.9.183):
In Reply to: NH Round Baler posted by Mr Green on September 30, 2002 at 20:55:50:
I just traded one last year for a 648 new holland. The the dealer gave me $2,500 for the 855. The 855 is a good baler. We baled on average 5-6,000 bales annualy with it. We went through it several times, replacing bearings and chains. It would have probably lasted me 10 more years at that rate, but the dealer offered me a deal that i couldn't resist on the 648. I definitely don't miss the 855. The bales are monsters and are heavy. Ten years ago you couldn't have gave me a 4x5 baler, but now you couldn't give me a baler that makes anything bigger than a 4x5, as they are easier to handle and most importantly easier to sell.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|