Re: Rough runnig 8N

Posted by CR on September 13, 2002 at 09:15:30 from (146.145.102.187):

In Reply to: Rough runnig 8N posted by Paul on September 12, 2002 at 18:24:36:

Paul,

You should not have that much play in the rotor. On some of the Fords there is a clip that goes between the rotor shaft and the rotor. It has been a while since I had mine apart so I don't remember if the 8n had one. I think it does. I do know that they seem to vanish when removing the rotor (i.e. they slide off with the rotor and fall out when you are not looking). Tractor will run terribly without it, as the timing will constantly be changing.
You can check on the N board. They will be able to tell you if the N should have the clip.

Hope this helps,

CR

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Rough runnig 8N Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]