|
Tractor Talk Discussion Board |
Re: Re: OT - Seeking wisdom, idioms for building out an attic
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by SHEP READ THIS REPLY on September 11, 2002 at 13:40:01 from (12.98.104.91):
In Reply to: Re: OT - Seeking wisdom, idioms for building out an attic posted by PatM - long answer on September 11, 2002 at 08:53:16:
Did Shep ever mention cutting trusses? looks like the bank is as much at fault as the owner... since when does a bank DEFER to the builder? Something smells a lot like fish to me on the deal.
Sounds more to me like the builder is caught between the home owner (who evidently didn't see that his plans had been spec'd out to meet code) and a woefully inept lender. Hey Shep... could you do a better job of explaining what happen with the code screw up?
That is where the blame should start then let the %^$& run down hill from there. Were the trusses approved in permit review? Did the builder install incorrect trusses that were approved by the county? You need to be a whole lot clearer on what happened between you, the builder, the county, and the lender before any CURE can come to your project. I was surprised that a professional constuction claims consultant was so ready to blame the builder without presenting the qustions that are glaringly obvious to another professional. Very suspect to me. Look deeper.
Just my 2 cents worth.
DWP
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
