|
Tractor Talk Discussion Board |
Re: Re: Re: Case VAC Generator operation
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ted A. to Bob M on September 09, 2002 at 20:04:22 from (64.12.96.236):
In Reply to: Re: Re: Case VAC Generator operation posted by Bob M w/ diagram link on September 09, 2002 at 18:35:52:
Thanks Bob, that looks about like what I have. I need to scrape a little deeper to see the terminal designations if they are still on the generator. Do you have any Idea what the cutout does. I took the cover off and I don't believe it is engaging at all. I do think the light switch is working OK because I measured the resistance with the battery disconnected and resistance to ground went from a value (several ohms) to ground when the switch was pulled out. When in operation the voltage should go from 6 volts to 8 volts but just sits there at 6.
Follow Ups:
Home
| Forums
Today's Featured Article -
Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
